HP ProCurve 520wl Wireless Access Point - Manual (Page 177)

Command Line Interface (CLI)
Security Parameters
For Dual-radio APs: WPA is available for APs with an HP ProCurve Wireless 802.11g AP Card 170wl.
Name Type Values Access CLI Parameter
Security Table N/A R secconfigtbl
Index Integer 3 (Single-radio APs)
3 or 4 (Dual-radio APs) R index
Authentication Mode Integer none (default)
802.1x
mixed
wpa
wpa-psk RW authmode
Re-keying Interval Integer 60 – 65535 seconds
default is 900 sec RW rekeyint
Encryption Key Length Integer 64bits
128bits RW enckeylen
Pre-Shared Key Configuration Table (WPA-PSK Mode)
Name Type Values Access CLI Parameter
WPA-PSK Pre-Shared
Key Table Table N/A R wpaconfigtbl
Index Integer 3 (Slot A) or 4 (Slot B) N/A index
Pre-Shared Key 1 DisplayString 64 hex digits WO pskey
PSK Pass Phrase 1 DisplayString 8 to 64 characters 2 WO passphrase
Note 1: Configure either the Pre-Shared Key or the PSK Pass Phrase (but not both) to create a pre-shared key for
WPA-PSK mode. Setting Pre-Shared Key will override a previous PSK Pass Phrase setting. Similarly, setting PSK
Pass Phrase will override a previous Pre-Shared Key setting.
Note 2: We recommend using a PSK Pass Phrase of at least 13 characters to ensure that the generated key cannot
be easily deciphered by network infiltrators.
Wireless Interface Security Parameters
The following table details the WEP encryption parameters for the AP.
Name Type Values Access CLI Parameter
Wireless Interface
Security Group R wifsec
Encryption Status Integer enable, disable (default) RW encryptstatus
Index Integer 3 (Single-radio APs)
3 or 4 (Dual-radio APs) R index
Encryption Key 1 DisplayString User Defined W encryptkey1
Encryption Key 2 DisplayString User Defined W encryptkey2
Encryption Key 3 DisplayString User Defined W encryptkey3
Encryption Key 4 DisplayString User Defined W encryptkey4
Data Transmission
Encryption Key Integer key1 (default), key2,
key3, key4 RW encryptkeytx
NOTE�
See WEP Encryption for information on the supported WEP Key lengths.
C-41