Command Line Interface (CLI)
Example 6 - Show Individual and Table Parameters
1. View a single parameter.
Syntax:
[Device-Name]>show
Example:
[Device-Name]> show ipaddr
Result: Displays the Access Point IP address.
Figure C-11 Result of “show ipaddr” CLI Command
2. View all parameters in a table.
Syntax:
[Device-Name]> show
Example:[Device-Name]> show mgmtipaccesstblResult: Displays the IP Access Table and its entries.
Using Tables & User Strings
Working with Tables
Each table element (or parameter) must be specified, as in the example below.
[Device-Name]>set mgmtipaccesstbl 0 ipaddr 10.0.0.10 ipmask 255.255.0.0
Below are the rules for creating, modifying, enabling/disabling, and deleting table entries.
• Creation
–
The table name is required.
–
The table index is required – for table entry/instance creation the index is always zero (0).
–
The order in which the table arguments or objects are entered in not important.
–
Parameters that are not required can be omitted, in which case they will be assigned the default value.
• Modification
–
The table name is required.
–
The table index is required – to modify the table, “index” must be the index of the entry to be modified.
–
Only the table objects that are to be modified need to be specified. Not all the table objects are required.
–
If multiple table objects are to be modified the order in which they are entered is not important.
–
If the entire table entry is to be modified, all the table objects have to be specified.
• Enabling/Disabling
–
The table name is required.
–
The table index is required – for table enabling/disabling the index should be the index of the entry to be
enabled/disabled.
–
The entry’s new state (either “enable” or “disable”) is required.
• Deletion
–
The table name is required.
–
The table index is required – for table deletion the index should be the index of the entry to be deleted.
–
The word “delete” is required.
C-11
