HP ProCurve 520wl Wireless Access Point - Manual (Page 180)

Command Line Interface (CLI)
Name Type Values Access CLI Parameter
Server IP Address or
Name IpAddress
Display String User Defined
(enter an IP address if
seraddrfmt is ipaddr or a
name if set to name; up
to 254 characters if
using a name) RW ipaddr
Port (optional) Integer User Defined
1813 (default) RW port
Shared Secret DisplayString User Defined
max 63 characters W ssecret
Response Time (sec) Integer 1 – 4 seconds
3 sec (default) RW responsetm
Maximum
Retransmissions
(optional) Integer 1 – 10
3 (default) RW maxretx
Rogue Access Point Detection (RAD) Parameters
Name Type Values Access CLI Parameter
Rogue Access Point Detection (RAD) Group N/A R rad
Status Integer enable
disable (default) RW radstatus
Scan Interval Integer 15-1440 (minutes) RW radscanint
Interface Bitmask Interface
Bitmask 4 (WiF A), 8 (WiF B), or 12
(both). RW radifbitmask
VLAN/SSID Parameters
Name Type Values Access CLI Parameter
VLAN Group N/A R vlan
Status Integer enable
disable (default) RW vlanstatus
Management ID VlanId -1 (untagged)
or 1-4094 RW vlanmgmtid
VLAN ID Table
NOTE�
16 VLAN/SSID pairs are available for APs with an HP ProCurve Wireless 802.11g AP Card 170wl only.
Name Type Values Access CLI Parameter
VLAN ID Table Table N/A R vlanidtbl
Index 1 Integer32 3.1 - 3.16 (Wireless A);
4.1 - 4.16 (Wireless B; Dual-radio APs only) R index
Identifier (ID) VlanId -1 or 0 (both correspond to untagged)
or 1-4094 RW id
Network Name (SSID) DisplayString 2-31 characters RW ssid
Status Integer enable (default when new entry created)
disable
delete RW status
Note 1: When adding a new entry to the table, you must specify the index instance you want to configure, such as 3.5;
the 0 index value is not applicable to this table and does not create a new entry.
C-44