HP ProCurve 520wl Wireless Access Point - Manual (Page 166)

Command Line Interface (CLI)
Interface Parameters
Wireless Interface Parameters
The wireless interface group parameter is wif. For Dual-radio APs, Slot A uses table index 3 and Slot B uses table
index 4.
Common Parameters to 802.11a, 802.11b, and 802.11b/g APs
Name Type Values Access CLI Parameter
Wireless Interfaces Group N/A R wif
Table Index Integer 3 (Slot A) or 4 (Slot B) R index
Network Name DisplayString 2 – 31 characters
My Wireless Network
(default) RW netname
Auto Channel Select (ACS) 1 Integer enable (default)
disable RW autochannel
DTIM Period Integer 1 – 255
1 = default RW dtimperiod
RTS/CTS Medium Reservation Integer 0 – 2347
Default is 2347 (off) RW medres
MAC Address PhyAddress 12 hex digits R macaddr
Closed System Integer enable
disable (default) RW closedsys
Supported Frequency Channels Octet String Depends on Regulatory
Domain R suppchannels
Load Balancing Integer enable (default)
disable RW ldbalance
Note 1: For 802.11a APs in Europe, Auto Channel Select is a read-only parameter; it is always enabled.
802.11a Only Parameters
Name Type Values Access CLI Parameter
Operating Frequency Channel Integer Varies by regulatory
domain and country. See
802.11a Channel
Frequencies
RW channel
Supported Data Rates Octet String See Transmit Rate ,
below
R suppdatarates
Transmit Rate Integer32 0 - Auto Fallback
(default)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec RW txrate
Physical Layer Type Integer ofdm (orthogonal
frequency division
multiplexing) for 802.11a R phytype
C-30