Command line interface (cli), C-43 – HP ProCurve 520wl Wireless Access Point User Manual
Page 179
Command Line Interface (CLI)
MAC Address Format
Integer
dashdelimited (default)
colondelimited
singledashdelimited
no delimiter
RW
radmacaddrformat
RADIUS Accounting
Status
Integer
enable
disable (default)
RW
radaccstatus
Accounting Inactivity
Timer
Integer32
0 – 2147483647
minutes; default is 5 min.
RW
radaccinactivetmr
RADIUS Authentication
NOTE�
Use a server name only if you have enabled the DNS Client functionality. See
.
Name
Type
Values
Access CLI Parameter
RADIUS Authentication Table
N/A
R
radiustbl
Primary MAC-based
authentication server
Integer
1
R
index
Backup MAC-based
authentication server
Integer
2
R
index
Primary EAP/802.1x
authentication server
Integer
3
R
index
Backup EAP/802.1x
authentication server
Integer
4
R
index
RADIUS Server Status
Integer
enable
disable (default)
RW
status
Server Addressing
Format (see note)
Integer
ipaddr (default)
name
RW
seraddrfmt
Server IP Address or
Name
IpAddress
DisplayString
User Defined
(enter an IP address if
seraddrfmt is ipaddr or a
name if set to name; up
to 254 characters if
using a name)
RW
ipaddr
Port (optional)
Integer
User Defined
1812 (default)
RW
port
Shared Secret
DisplayString
User Defined
max 63 characters
W
ssecret
Response Time (sec)
Integer
1 – 4 seconds
3 sec (default)
RW
responsetm
Maximum
Retransmissions
(optional)
Integer
1 – 10
3 (default)
RW
maxretx
RADIUS Accounting
NOTE�
Use a server name only if you have enabled the DNS Client functionality. See
.
Name
Type
Values
Access CLI Parameter
RADIUS Accounting
Table
N/A
R
radacctbl
Primary RADIUS
Integer
1
R
index
Backup RADIUS
Integer
2
R
index
RADIUS Server Status
Integer
enable
disable (default)
RW
status
Server Addressing
Format (see note)
Integer
ipaddr (default)
name
RW
seraddrfmt
C-43