Other parameters, Iapp parameters, Spectralink voip parameters (802.11b only) – HP ProCurve 520wl Wireless Access Point User Manual
Page 181: Command line interface (cli) other parameters, C-45
Command Line Interface (CLI)
Other Parameters
IAPP Parameters
Name
Type
Values
Access CLI Parameter
IAPP
Group
N/A
R
iapp
IAPP Status
Integer
enable (default)
disable
RW
iappstatus
Periodic Announce
Interval (seconds)
Integer
80
120 (default)
160
200
RW
iappannint
Announce Response
Time
Integer
2 seconds
R
iappannresp
Handover Time-out
Integer
410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW
iapphandtout
Max. Handover
Retransmissions
Integer
1 - 4 (default 4)
RW
iapphandretx
Send Announce
Request on Startup
Integer
enable (default)
disable
RW
iappannreqstart
NOTE�
These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
SpectraLink VoIP Parameters (802.11b Only)
Name
Type
Values
Access CLI Parameter
Spectralink VoIP
Group
N/A
R
spectralink
Spectralink VoIP Status
Integer
enable
disable (default)
RW
speclinkstatus
C-45