Set net v6 manual, Set net v6 stateless, Set net v6 manual set net v6 stateless – HP Command View for Tape Libraries Software User Manual

Page 214

show net info

set net v6 manual

NOTE:

To use this command, first enable IPv6 using the

set net v6 ipversion

command.

Description

Configures the Interface Manager to accept a user-provided network address
for the public network interface.

Syntax

set net v6 manual

[[on] |

[off] force

]

NOTE:

The off argument removes all manually configured network addresses

Availability

All users and modes

Operands

[[on] | [off] force]

Examples

To configure the Interface Manager to accept a user-provided network address
for the public network interface.:

/>set net v6 manual on

Add IPv6 address. Select Prefix
1) 2620:0:a07:e00a::
2) fe80::
Enter a selection or 'Q' to quit [default='Q']: 1
Enter interface identifier. xxxx:xxxx:xxxx:xxxx, a single
'::' is allowed.
Enter a selection or 'Q' to quit [default='Q']: a:b:c:d
Caution: Changing Manual addressing may cause your CLI
session to terminate(for a telnet/ssh user), and you may have
to log on again.
Do you really want to enable Manual addressing?
Enter 'y' to continue or 'n' to skip [default='n']: y
ipAddress = 2620:0000:0a07:e00a:000a:000b:000c:000d/64
Operation status: Starting to change network.
Operation status: Finished Updating Network Settings