Show network dhcp, Show network ipaddress, Show network snmpcommunity – HP Command View for Tape Libraries Software User Manual
Page 242

- IPv6 Addresses Type
2620:0000:0a07:e00a:0001:0002:0003:0004/manual
2620:0:a07:e00a:280:66ff:fe05:f956/64 stateless
2620:0:a07:e00a:485c:8517:cdb:6a83/64 dhcpv6
fe80::280:66ff:fe05:f956/64 link-lcl
See also
show network dhcp
Description
Shows whether DHCP mode is enabled or disabled. When enabled, DHCP
is used to set the Interface Manager card IP address.
Syntax
show network dhcp
Availability
All users and modes
Operands
None
Examples
To show whether DHCP mode is enabled or disabled:
/>show network dhcp
DHCP: disabled
See also
show network ipaddress
Description
Displays the current IP address, subnet mask, and gateway address for the
Interface Manager card.
Syntax
show network ipaddress
Availability
All users and modes
Operands
None
Examples
To show the current IP address, subnet mask, and gateway address:
/>show network ipaddress
DHCP: disabled
IP address: 207.46.249.190
Subnet mask: 255.255.248.0
Gateway address: 207.46.72.1
See also
show network snmpcommunity
Description
Shows the Simple Network Management Protocol (SNMP) community strings.
SNMP is a well-defined standard of reporting device information through a
network. The Interface Manager card has a built-in SNMP agent that supports
queries to MIB-II in addition to SNMP traps/alerts. This command also shows
all defined SNMP traps.
Syntax
show network snmpcommunity
Availability
All users and modes
Operands
None
242 CLI Command Reference