Show interface hostport sid, Show interface hostport speed – HP Command View for Tape Libraries Software User Manual
Page 230
Syntax
show interface hostport mode [interface_num] | [all]
[port_num] | [all]
Availability
All users and modes
Operands
Specify an interface number. The mode may be
displayed for all interfaces by specifying all for this
operand. This operand is required.
interface_num
port_num
Specify a port number. The mode may be displayed for
all ports by specifying all for this operand. This
operand is required.
Examples
To show the port modes for all interfaces:
/>show interface hostport mode all all
Interface port mode:
Interface Card WW Port Num Connection type
---------------- ----------------- ----–----------
1
hostport1 FFFFFFFFFFFFFFFF N-Port
hostport2 AAAAAAAAAAAAAAAA N-Port
See also
show interface hostport sid
Description
Shows the source identifier for the port entered or all ports.
Syntax
show interface hostport sid
[ interface_num | [all]] [
port_number | [all]
]
Availability
All users and manual mode
Operands
Specify the number of the interface. The value may be
changed for all interfaces by specifying all for this
operand. This operand is required.
interface_num
port_number
Specify the number of the port. The value may be
changed for all ports by specifying all for this operand.
This operand is required.
Examples
To show the port speeds for interface 1:
/>show interface hostport sid all all
Interface fibre-Channel port settings:
Interface Card WW Port Name Port # SID
----------------- -------------------- ------ -----------
Interface Card 1 100000e00222a7a0 0 0x0
Interface Card 1 100000e00242a7a0 1 0x11b00
See also
show interface hostport speed
Description
Shows the port speeds of one or more interfaces.
Syntax
show interface hostport speed interface_num port_num
Availability
All users and manual mode
Operands
Specify the number of the interface. The value may be
changed for all interfaces by specifying all for this
operand. This operand is required.
interface_num
port_num
Specify the number of the port. The value may be
changed for all ports by specifying all for this operand.
This operand is required.
230 CLI Command Reference