6 troubleshooting, Led diagnostic codes, Common issues – HP Command View for Tape Libraries Software User Manual
Page 249: Led diagnostic codes common issues
6 Troubleshooting
For common problems and how to resolve them, see the following sections:
•
•
For additional support, go to the following website:
LED diagnostic codes
Table 37 Status LED diagnostic codes
Description
Green LED
Red LED
BIOS code failed to run.
Off
On
Hardware POST failed. No firmware images are loaded.
Off
Blinks 1x per 5 second
interval
No CompactFlash disk or valid boot sector image found.
Off
Blinks 2x per 5 second
interval
Specified firmware image files were not found. Neither the
current nor the previous image was found.
Off
Blinks 3x per 5 second
interval
Load or execute command failed (boot code remains at end
of process). This indicates that load, decompress, or execution
failed on both the current and previous image files.
Off
Blinks 4x per 5 second
interval
Flash is read-only. Replace with 488160-001 (256 MB for
use on the 342213-001 or 393531-001 (AS#340252-001
Off
Blinks 5x per 6 second
interval
or AS#340252-002) Interface Manager card) 439651-001
(1 GB for use on the 480240-001 (AS#340252-003) Interface
Manager card).
Load or execute command succeeded. Boot code successfully
loaded, decompressed, and initiated execution of one of the
image files.
Blinks 1x per 5 second
interval
Off
Application software is initializing.
Blinks 2x per 5 second
interval
Off
Application is identifying all library components.
Blinks 3x per 5 second
interval
Off
Normal state. Application has identified all library components.
On
Off
Table 38 Network link activity/speed LEDs
Description
Status
LED
Port disconnected/no link
Off
Link Activity LED (left side of
each Ethernet port)
Port connected to another Ethernet device
On
Data is being transmitted/received
Flashing
Port is operating at 100 Mbps
On
Link Speed LED (right side of
each Ethernet port)
Port is operating at 10 Mbps, or port is not connected (see Link Activity
LED)
Off
Common issues
Common issues are organized into the following categories:
LED diagnostic codes 249