Show interface access, Show interface beacon, Show interface access show interface beacon – HP Command View for Tape Libraries Software User Manual
Page 228
Operands
Displays whether the ftp service is enabled or disabled.
ftp
telnet
Displays whether the telnet service is enabled or disabled.
tlogin
Displays whether the rlogin service is enabled or disabled.
all
Displays whether the ftp, telnet, and rlogin services are
enabled or disabled.
Examples
To show whether the rlogin service is enabled or disabled::
/>show inet rlogin
rlogin is Disabled
To show whether ftp, telnet, and rlogin are enabled or disabled::
/>show inet all
ftp is Enabled
telnet is Enabled
rlogin is Disabled
See also
show interface access
Description
Shows access information at the interface level. This command lists all tape
drives connected to the specified interface. For each tape drive listed, the
command shows which hosts have access to it, and the target LUN giving the
host access to the drive.
Syntax
show interface access [interface_num] | [all]
Availability
All users and modes
Operands
Specify the interface for which to display access
information. The access information may be displayed
interface_num
for all interfaces by specifying all for this operand.
This operand is required.
Examples
To show interface access information for interface 1:
/>show interface access 1
Interface access information:
Interface 1 tape drives:
Access information for drive 1:
Host Host Name WW Node Name LUN Port
-------- ---------------------- -------------------- ----
1 myhost1 FFFFFFFFFFFFFFFFFFFF 1 1
See also
show interface beacon
Description
For HP StorageWorks e2400-4Gb FC interface controllers, shows whether
the beacon is currently on or off.
Syntax
show interface beacon [interface_num] | [all]
Availability
All users and modes
Operands
Specify the interface for which you want to show the
beacon state. The beacon state may be displayed for
interface_num
all interfaces that have beacons by specifying all for
this operand. This operand is required.
Examples
To show the state of the beacon on interface 3:
/>show interface beacon 3
Interface 3 beacon: Off
To show the state of the beacons on all interfaces:
/>show interface beacon all
228 CLI Command Reference