HP Command View for Tape Libraries Software - Manual (Page 216)

9. Use the + and — keys to change the hours, minutes, and seconds to the correct values.
These values are set but not saved.
10. Press Esc to return to the main menu.
11. At the Save Changes and Exit? prompt, enter Y.
The date and time is now saved. The HP StorageWorks Interface Manager reboots. The
six-month HP service password works.
set network dhcp
Description Enables or disables DHCP mode to set the Interface Manager card IP address.
If DHCP is disabled, the Interface Manager card IP address, gateway address,
and subnet mask must be set using set network ipaddress before the
Interface Manager card CLI can be accessed via Telnet/SSH.
Syntax set network dhcp
Availability All users and modes
Operands None
Examples To enable using DHCP to set the IP address of the Interface Manager card:
/>set network dhcp
Committing configuration...done
See also show network dhcp
set network ipaddress
show network ipaddress
set network ipaddress
Description Sets the IP address, subnet mask, and gateway address for the Interface
Manager card. This command automatically disables DHCP mode.
Syntax set network ipaddress ip subnet gateway
Availability All users and modes
Operands Specify the IP address that the Interface Manager card should
use. This operand is required. ip
subnet Specify the subnet mask that the Interface Manager card should
use. This operand is required.
gateway Specify the gateway address that the Interface Manager card
should use. This operand is required.
Examples To immediately change the IP address to 207.46.249.190, change the subnet
mask to 255.255.248.0, and change the current gateway address to
207.46.249.0:
/>set network ipaddress 207.46.249.190 255.255.248.0 207.46.249.0
Committing configuration...done
Closing telnet/ssh session.
See also show network dhcp
set network dhcp
show network ipaddress
set network snmpcommunity
Description Sets the appropriate Simple Network Management Protocol (SNMP) community
string. SNMP is a well-defined standard of reporting device information through
216 CLI Command Reference