HP XP P9500 Storage - Manual (Page 123)

format
<2HexLDKC>:<2HexCU>:<2HexLDEV>
•
<2HexLDKC> : LDKC number (two-digit hexadecimal) of the single virtual volume to be specified
•
<2HexCU> : CU number (two-digit hexadecimal) of the single virtual volume to be specified
•
<2HexLDEV> : LDEV number (two-digit hexadecimal) of the single virtual volume to be specified
Example
VVolForSnapshot=00:00:00to00:00:FF,00:02:00,00:04:00to00:04:FF
In this example, a virtual volume having one of the following LDEV IDs is used as the snapshot
target:
•
From 00:00:00 (LDKC=0,CU=0,LDEV=0) to 00:00:FF (LDKC=0,CU=0,LDEV=255)
•
00:02:00 (LDKC=0,CU=2,LDEV=0)
•
From 00:04:00 (LDKC=0,CU=4,LDEV=0) to 00:04:FF (LDKC=0,CU=4,LDEV=255)
PoolIDForSnapshot parameter
Use the PoolIDForSnapshot parameter to specify pools that the SMI-S provider can use when
you run Fast Snap or Copy-on-Write Snapshot from CreateElementReplica of
ReplicationService.
All pools are specified by default.
Setting up the PoolIDForSnapshot parameter
Set up the parameter by using and with a comma (,) as
a delimiter:
•
: Specifies a range of pool IDs
•
: Specifies a single pool ID
format
to
•
: ID of the first pool in the specified range
•
: ID of the last pool in the specified range
format
•
: ID of the pool to be specified
Example
PoolIDForSnapshot=1to2,4,6to8
In this example, pools having one of the following pool IDs are used as snapshot pools:
•
1 to 2
•
4
•
6 to 8
DefaultSnapshotFunction parameter
Use the DefaultSnapshotFunction parameter to specify either Fast Snap or Copy-on-Write
Snapshot from CreateElementReplica of ReplicationService. Copy-on-Write Snapshot is
specified by default.
User-defined.properties file 123