HP XP Continuous Access Software User Manual
Page 155
The first line displays the primary data volume's port number, G-ID, and LUN. The G-ID is the group
number of a host group or iSCSI target. If the primary data volume exists in the local array, the first
line also displays the CLPR number and name.
The second line displays the device emulation type.
The third line displays the volume capacity.
NOTE:
If a logical volume is an external LU, # appears after the LDEV number. For more information about
external LUs, see the
HP StorageWorks External Storage XP user guide
.
If there is no primary data volume in the local subsystem, the port ID, G-ID, and LUN of the volume
that you specified in the remote subsystem when creating the pair will be displayed. If you change or
delete the port ID, G-ID, or LUN of the volume in the remote subsystem, incorrect information will be
displayed. So, unless you have any special circumstances, do not change or delete the port ID, G-ID,
or LUN that you specified when creating the pair.
•
S-VOL: Secondary data volume.
The first line displays the secondary volume's port number, G-ID, and LUN. The G-ID is the group
number of a host group or iSCSI target. If the secondary data volume exists in the local array, the first
line also displays the CLPR number and name.
The second line displays the device emulation type.
The third line displays the volume capacity.
NOTE:
If a logical volume is an external LU, # appears after the LDEV number. For more information about
external LUs, see the
HP StorageWorks External Storage XP user guide
.
If there is no secondary data volume in the local subsystem, the port ID, G-ID, and LUN of the volume
that you specified in the remote subsystem when creating the pair will be displayed. If you change or
delete the port ID, G-ID, or LUN of the volume in the remote subsystem, incorrect information will be
displayed. So, unless you have any special circumstances, do not change or delete the port ID, G-ID,
or LUN that you specified when creating the pair.
•
CLPR: CLPR number and name of the logical volume in the local array.
•
M-JNL Group: Master journal group.
•
R-JNL Group: Restore journal group.
•
Mirror ID: Mirror ID.
•
CT Group: Consistency group number.
•
DKC S/N (CTRL ID): Secondary array's serial number and controller ID. The controller ID is
enclosed by parentheses.
•
Path Type: Channel type of the path interface between the arrays (fibre, serial).
NOTE:
In the current version, the channel type is always displayed as Fibre.
•
Initial Copy Priority: Initial copy operations priority (scheduling order). The value can be within
the range of 1 to 256 (disabled when the status becomes PAIR).
•
Error Level: Range used for splitting a pair when a failure occurs.
• Group: If a failure occurs with a pair, all pairs in the consistency group where the pair
belongs are split.
• LU: If a failure occurs with a pair, only the pair is split.
•
S-VOL Write: Indicates whether write I/O to the secondary data volume is enabled or disabled
(enabled only when the pair is split).
Continuous Access XP Journal user guide
155