HP XP Continuous Access Software User Manual
Page 106

• Remote array's serial number.
• Remote array's controller ID.
NOTE:
The controller ID for an XP12000/XP10000 is 4.
• Path group ID. The path group ID is within the range of 1-FF (hexadecimal). Up to 64 path
group IDs can be registered per array.
NOTE:
In the current version, the path group IDs always take the default values and cannot be changed.
8.
In the Add DKC pane, select a primary and remote array port to configure a logical path.
9.
Click Option.
10.
In the DKC Option pane, configure the logical path and array options. For more information, see
Changing options for logical paths and arrays
11.
Click Set to close the DKC Option pane.
12.
In the Preset list, check the settings you made.
• To modify a setting, right-click the setting from the Preset list, and select Modify. A pane
appears where you can modify the setting.
• To cancel a setting, right-click the setting in the Preset list, and select Cancel.
13.
Click Apply to apply the settings.
NOTE:
If an error occurs, the right-most column of the Preset list displays the error code. To view
detailed information about the error, right-click the error code, and select Error Detail. An
error message appears providing detailed information about the error.
106
Configuring arrays and logical paths