HP XP Continuous Access Software - Manual (Page 146)

NOTE:
Information on the Pair Operation pane is updated when you do one of the following:
• Select another tab, and reselect the Pair Operation tab.
• Click Refresh ( ) (top right of Command View XP or XP Remote Web Console pane).
• Click Apply.
• Select Modify mode when you are in View mode.
Filtering information in the list on the Pair Operation pane
Use the Display Filter pane to filter information in the list on the Pair Operation pane. The list displays
only volumes that satisfy certain conditions.
1. In the Pair Operation pane ( Figure 56 ), click Display Filter.
2. In the Display Filter pane, specify information you want to display in the list.
3. Click Set to close the Display Filter pane.
NOTE:
•
To restore the list to the default status (that is, the status before filtering), click Reset in the Display
Filter pane, and click Set in the same pane.
• If you change settings in the Display Filter pane, the changes remain in effect during the Continuous
Access XP Journal session until you reset the settings.
Figure 59 Display Filter pane
•
Port: Port to be displayed. To display all ports, select ALL.
NOTE:
You can specify the port number with two characters. For instance, you can abbreviate CL1-A to 1A.
You can also enter the port number in both lowercase and uppercase characters.
146 Performing Continuous Access XP Journal pair operations