HP XP Continuous Access Software - Manual (Page 132)

• Path Watch Time (min): Time for monitoring blockade of paths to the remote array. If the
status of a mirror where secondary data volumes in the local array are registered is Hold or
Hold(Failure), this column is blank.
• Volume: Number of data volumes registered in the mirror.
• Capacity: Total capacity of data volumes registered in the mirror.
• Previous: Displays detailed information about the previous journal group.
• Next: Displays detailed information about the next journal group.
• Close: Closes the JNL Group Detail pane.
Changing options for journal groups
If you are logged onto an XP10000, you can perform this operation only on journal groups that have
a number below 10.
To change a journal group's options, the primary and secondary array administrators must perform the
following procedure:
1. Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Display the Journal Operation pane (see Displaying the Journal Operation pane ).
3. Do one of the following:
• In the tree, right-click a journal group from below Registered, and select JNL Groups and
Change JNL Option.
• In the upper-right list, right-click the desired journal group, and select JNL Groups and
Change JNL Option.
CAUTION:
You can select Change JNL Option only when one of the following conditions is satisfied:
• Journal group's attribute is Initial.
• Journal group's status is Stop.
• Journal group's status is Active.
• Status of the journal group is Hold.
• Status of the journal group is Hold(Failure).
When one journal group uses multiple mirror IDs, whether or not you can Change JNL Option
depends on the status of the journal group whose mirror is not in Hold or Hold(Failure) status.
4. In the Change JNL Option pane ( Figure 54 ), change journal group options, and click Set.
CAUTION:
If the journal group's status is Active or if the master journal group's status is Hold, you
can change only the Line of Speed option.
NOTE:
If you selected two or more journal groups in step 3 and want to leave some options in
the Change JNL Options pane unchanged, specify blank for the options. If you specify
blank for an option, the option value remains unchanged. If you specify a value other than
blank, the specified value is set to the selected journal groups.
5. In the Preset list, check the settings you made.
132 Using journal groups