Deleting logical paths, Add path pane – HP XP Continuous Access Software User Manual
Page 110

NOTE:
If an error occurs, the right-most column of the Preset list displays the error code. To view
detailed information about the error, right-click the error code, and select Error Detail. An
error message appears providing detailed information about the error.
Figure 45 Add Path pane
•
Port: Select an initiator port on the local array.
NOTE:
When specifying a port, use the keyboard to enter the port number. When entering the port number,
you can abbreviate the port number to two characters. For example, you can enter 1A instead of
CL1-A. You can use uppercase and lowercase letters.
•
Pair-Port: Select an RCU target port on the remote array.
NOTE:
When specifying a port, use the keyboard to enter the port number. When entering the port number,
you can abbreviate the port number to two characters. For example, you can enter 1A instead of
CL1-A. You can use uppercase and lowercase letters.
•
Set: Closes the Add Path pane, and adds settings to the Preset list.
•
Cancel: Cancels settings.
Deleting logical paths
Before deleting logical paths, ensure that the remaining number of logical paths will be greater than the
minimum number of paths setting (see
Changing options for logical paths and arrays
). The delete path
operation fails if the number of remaining paths is equal to or less than the minimum number of paths.
To delete logical paths, the primary and secondary array administrators can perform the following
procedure:
110
Configuring arrays and logical paths