HP XP Continuous Access Software User Manual
Page 145

• If the volume pair is split and, therefore, is in PSUS or PSUE status, this column usually
displays the synchronization rate (that is, concordance rate) between the secondary data
volume before it was split and the secondary data volume after it was split. For example,
the synchronization rate is 100 percent if the contents of the secondary data volume is the
same before and after the volume pair was split.
CAUTION:
If a failure in the initial copy operation causes the volume pair to be split, this column displays
nothing. If a failure occurs in the initial copy operation, the Pairdisplay pane displays Initial
copy failed.
In the following cases, this column is blank:
• When the volume in the local is not a primary or secondary data volume.
• When the status of the volume pair is HOLD or HLDE.
• CLPR: Number and name of the CLPR where the data volume belongs.
•
Used Volume: Size of used volumes and licensed capacity. For example, if 12.34 (15.00) (TB)
is displayed, the licensed capacity for Continuous Access XP Journal is 15.0 terabytes, and
12.34 terabytes of volumes are used.
•
Total Pairs: Current total number of data volume pairs.
•
Preset: Detailed information about operations that will occur when you click Apply.
• List: Displays changes made in the pane. When you change settings in the pane, the changes
are displayed in the Preset list before being applied to the arrays. If you are sure that
information in the Preset list is correct, click Apply to apply the settings you made.
NOTE:
When the Preset list displays the changes made, you can only perform the same type of operation
you have been doing and cannot perform most other operations. You can only view detailed
information about pairs even when the Preset list displays changes. For example, if you are trying
to delete pairs and the Preset list displays the pairs you want to delete, you cannot perform any
other operations, such as splitting or restoring pairs.
• Operation: Operation that will occur when you click Apply.
• Paircreate: Creates pairs
• Pairsplit-r: Splits pairs
• Pairresync: Restores pairs
• Pairsplit -S: Deletes pairs
• Change Pair Option: Changes pair options
• Blank: Nothing occurs when you click Apply.
• Preset: The number to the left of the slash (/) indicates the number of items displayed in the
Preset list. The number to the right of the slash indicates the maximum number of items that
can be displayed in the Preset list. For example, if Preset 010/1096 is displayed, you can
add another 4,086 items to the Preset list.
•
Apply: Applies settings in the Preset list to the arrays.
•
Cancel: Cancels settings in the Preset list.
Continuous Access XP Journal user guide
145