Tracking switch changes, Enabling the track changes feature – HP StorageWorks MSA 2.8 SAN Switch User Manual
Page 63

Basic Switch Management
63
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
Tracking Switch Changes
The Track Change feature allows you to keep a record of specific changes that
may not be considered switch events, but may be useful. The output from the track
changes feature is dumped to the error log for the switch. Use the
errdump
command or
errshow
command to view the error log.
Items in the error log created from the Track changes feature are labeled
TRACK
.
Trackable changes are:
— Successful login
— Unsuccessful login
— Logout
— Config file change from task
— Track-changes on
— Track-changes off
An SNMP-TRAP mode can also be enabled. Refer to the
trackchangeshelp
command in the HP StorageWorks Fabric OS Version 3.1.x/4.1.x Reference Guide.
Enabling the Track Changes Feature
To enable the track changes feature:
1. Log into the switch as the admin user.
2. Enter the
trackchangesset 1
command at the command line to enable
the track changes feature.
A prompt is displayed verifying that the track changes feature is on.
Example:
The output from the track changes feature is dumped to the error log for the
switch. Use the
errdump
command or
errshow
command to view the error
log.
Items in the error log created from the Track changes feature are labeled
TRACK
.
switch:admin> trackchangesset 1
Committing configuration...done.
switch:admin>