HP StorageWorks MSA 2.8 SAN Switch - Manual (Page 16)

Initial Configuration
16 Fabric OS Procedures Version 3.1.x/4.1.x User Guide
8. Enter the ippaddrset command to verify the data you entered, and exit.
9. Repeat the steps to configure all SAN Switch 2/32 switches.
Example:
Configuring IP Addresses for the Core Switch 2/64
For the Core Switch 2/64, there are a number of Ethernet IP addresses and Fibre
Channel IP addresses to set. The procedures below describes how to configure
first the Control Processors, then the logical switches.
Table 1 describes the different areas that must be configured for a Core Switch
2/64.
Configuring the Control Processors:
1. Have the following information available:
— Ethernet IP Address
switch:admin> ipaddrset
Ethernet IP Address [10.77.77.77]: 10.64.119.7
Ethernet Subnetmask [10.77.77.76]: 255.255.240.0
Fibre Channel IP Address [0.0.0.0]:
Fibre Channel Subnetmask [0.0.0.0]:
Gateway IP Address [10.64.112.1]:
IP address being changed...
Committing configuration...Done.
switch:admin>
Table 1: Areas to be Configured for the Core Switch 2/64
Logical Switch 0
(Slots 1 - 4) CP 0 (Slot 5) CP 1 (Slot 6)
Logical Switch 1
(Slots 7 - 10)
Ethernet IP Address Ethernet IP Address Ethernet IP Address Ethernet IP Address
Ethernet Subnetmask Ethernet Subnetmask Ethernet Subnetmask Ethernet Subnetmask
Fibre Channel IP
Address (Optional)
Hostname Hostname Fibre Channel IP
Address (Optional)
Fibre Channel
Subnetmask
Gateway IP Address Gateway IP Address Fibre Channel
Subnetmask