beautypg.com

Changing the admin password in v3.1 firmware – HP StorageWorks MSA 2.8 SAN Switch User Manual

Page 22

background image

Initial Configuration

22

Fabric OS Procedures Version 3.1.x/4.1.x User Guide

Changing the Admin Password in v3.1 Firmware

For security reasons, the first time you log into the Fabric OS you are requested to
change the system password. The following procedure applies specifically to v3.1.

To change the admin password:

1. Log into the switch as the admin user.

2. Enter the

passwd

admin command. In v3.0.1 you must specify the user

level when modifying the password.

Note:

Quotation marks must be used for complete initialization of this command.

Example:

3. An interactive session is started where you can change the admin user name

and the password. If you want to change the admin user name, at the New
username prompt, enter a new name for the admin user. Click Return without
changing the value to leave it as is. You can change the password of the admin
user without changing the user name.

4. At the

Old password

prompt, enter the old password.

5. At the

New password

prompt, enter the new password. The new password

must be at least 8 characters in length.

6. At the

Re-enter new password

prompt, enter the new password

exactly as entered in the previous prompt. Press the Enter key to save the new
password to the firmware.

Example:

switch:admin> passwd "admin"

switch:admin> passwd "admin"

New username [admin]:

Old password: xxxxxxxx

New password: xxxxxxxx

Re-enter new password: xxxxxxxx

Saving passwd...done.