HP StorageWorks MSA 2.8 SAN Switch - Manual (Page 50)

Basic Switch Management
50 Fabric OS Procedures Version 3.1.x/4.1.x User Guide
Usually the Made on and Flash dates are the same, since the switch starts running
flash firmware at power-on. However, in the time period between
firmwareDownload and the next reboot, the dates can differ.
3. Enter the firmwareShow command.
Use this command to display the Fabric OS versions on primary and
secondary partitions on the local CP and on the remote CP. This command
identifies the status for each CP as Active or Standby, and will also identify
the slot number for each CP.
If there is only one CP available, the command displays the Fabric OS
versions for the primary and secondary partitions on that CP.
Example: SAN Switch 2/32
Example: Core Switch 2/64
Fabric OS Displays the version of switch Fabric OS
Made on Displays the build date of firmware running in switch
Flash Displays the build date of firmware stored in flash proms
BootProm Displays the version of the firmware stored in the boot PROM
switch232:admin> firmwareshow
Local CP (Slot 5, CP0): Active
Primary partition: v4.0.2
Secondary Partition: v4.0.2
Remote CP is Non-redundant.
switch232:admin>
switch264:admin> firmwareshow
Local CP (Slot 5, CP0): Active
Primary partition: v4.0.2
Secondary Partition: v4.0.2
Remote CP (Slot 6, CP1): Standby
Primary partition: v4.0.2
Secondary Partition: v4.0.2
switch264:admin>