HP StorageWorks MSA 2.8 SAN Switch User Manual

Page 129

The SAN Management Application

129

2. At the command line enter the

msconfigure

command. The command

becomes interactive.

3. At the select prompt enter 2 to add a member based on its Port/Node WWN.

4. At the prompt enter the WWN of the member you would like to add to the

ACL. Press the Return key, and the main menu is displayed.

5. At the prompt enter 1 to verify the WWN you entered was added to the ACL.

6. Once you have verified that the WWN was added correctly, enter 0 at the

prompt to end the session.

7. At the “Update the FLASH?” prompt enter Y.

8. Press Enter to update the flash and end the session.

Example:

switch:admin> msconfigure

0 Done

1 Display the access list

2 Add member based on its Port/Node WWN

3 Delete member based on its Port/Node WWN

select : (0..3) [1] 2

Port/Node WWN (in hex): [00:00:00:00:00:00:00:00]

*WWN is successfully added to the MS ACL.

0 Done

1 Display the access list

2 Add member based on its Port/Node WWN

3 Delete member based on its Port/Node WWN

select : (0..3) [2] 1

<< Continued on next page.>>