HP StorageWorks MSA 2.8 SAN Switch - Manual (Page 26)

Initial Configuration
26 Fabric OS Procedures Version 3.1.x/4.1.x User Guide
Activating a License
1. Log into the Command Line Interface as the Admin user.
2. To activate a license, you must have a valid license key. Use the license key
provided in the licensed Paper Pack.
Activate the license using the licenseadd command, as follows:
Example:
Note: The license key is case-sensitive and must be entered exactly as given, enclosed
in double quotes.
3. Verify that the license was added by entering the licenseshow command
at the command line prompt.
A list displays all of the licenses currently installed on the switch.
Example:
If the licensed feature is listed, the feature is installed and immediately available.
If the license is not listed, repeat step 2 of this procedure.
Verifying License Activation
To verify that the required licenses are activated on the switch, perform the
following steps:
1. Log into the Command Line Interface as the Admin user.
2. Enter the licenseshow command at the command line prompt.
A list displays all of the licenses currently activated on the switch.
switch:admin> licenseadd “key”
switch:admin> licenseshow
1A1AaAaaaAAAA1a:
Web license
Zoning license
SES license
Security license
Fabric Watch license