Agilent Technologies N2620A - Manual (Page 79)

Network Testing with the FrameScope Pro 2
N2620A User’s Guide 61
9 Press Start to begin the test.
Once Start is pressed, the master FrameScope Pro starts the
activation and the synchronization procedure with the target
FrameScope Pro by doing the following actions.
a Search (if enabled) and check the status of the slave
FrameScope Pro.
b Activate the slave FrameScope Pro if the device is in idle
mode.
c Authenticate the master FrameScope Pro if a password is
enabled.
d Set up the slave FrameScope Pro parameters by
synchronizing the master and slave FrameScope Pro units
for the test.
e Start the test.
f Query test results at the end of the test.
g Stop the test.
If the target selected is a loopback device, all test setups are
performed in the master FrameScope Pro. There will be no
authentication synchronization setup.