Agilent Technologies N2620A User Manual
Page 71
Network Testing with the FrameScope Pro
2
N2620A User’s Guide
53
Setting Up the Master FrameScope Pro for RFC 2544 Tests
To perform an RFC 2544 test, you will need two FrameScope
Pro units, one as master and the other as slave, or a
FrameScope Pro and a loopback device. For initial settings on
the master FrameScope Pro, refer to
on page 49 before proceeding with the
procedure below.
1
If the slave destination is a FrameScope Pro, ensure that the
slave FrameScope Pro is ready for the RFC 2544 test. For the
slave FrameScope Pro settings, refer to
FrameScope Pro for RFC 2544 Tests”
2
Select RFC 2544 Test on the Performance Tests menu.
3
Select Throughput, Latency, Frame Loss Rate, and Back-To-Back
RFC 2544 test options.
Press Suite to
load or create
new test suite.
Select RFC 2544
test options.
Press Settings to
set specific RFC
test parameters.