GW Instek PPH-1503 - Manual (Page 135)

APPENDIX
135
LONG INTEGRATION PULSE
TIMEOUT 1S ~ 63S
LONG INTEGRATION
MEASUREMENT TIME 850ms(60Hz)/840ms(50Hz) ~
60s,or AUTO time
16.7ms/steps(60Hz),
20ms/steps(50Hz)
LONG INTEGRATION TRIGGER
MODE Rising, Falling, Neither
OVP OVP RANGE OFF,ON (0 ~ 15.2V)
RESOLUTION 10mV
ACCURACY 50mV
Others PROGRAMMING IEEE-488.2(SCPI)
USER_DEFINABLE POWER_UP
STATES 5 sets
REAR PANEL CONNECTOR 8Pin:output*4, sense*2, DVM*2
TEMPERATURE COEFFICIENT 0.1* specification/ ˚C
POWER CONSUMPTION 150VA
REMOTE/LOCATION CONNECTOR USB/GPIB/LAN
RELAY CONTROL CONNECTOR 150mA/15V 5Voutput, 100mA
Insulation Chassis and Terminal 20MΩ or above (DC 500V)
Chassis and AC cord 30MΩ or above (DC 500V)
Operation
Environment Indoor use, Altitude: ≤ 2000m
Ambient temperature: 0 ~ 40°C
Relative humidity: ≤ 80%
Installation category: II, Pollution
degree: 2
STORAGE
Environment
TEMPERATURE: -20˚C ~ 70˚C
HUMIDITY: < 80%
INPUT POWER 90-264VAC, 50/60Hz 6
Accessories CD 8cmUser manual x1, Quick Start manual x1
Test lead GTL-117 x 1
GTL-203A x 1, GTL-204A x 1
Dimensions 222 (W) x 86 (H) x 363 (D) mm
Weight Approx. 4.2kg
Remarks 1 PLC=PowerLineCycle, 1PLC = 16.7ms for 60Hz operation, 20ms for
50Hz operation;
2 Display OFF, Speed includes measirement and binary data transfer out
of GPIB;
3 PLC=1;
4 STABILITY:Following 15 minute warm-up, the change in output over 8
hours under ambient temperature, constant load, and line operating
conditions;
5 The ground ring of the probe is pressed directly against the output
ground of the power supply and the tip is in contact with the output
voltage pin.
6 Auto detected at power-up;