GW Instek PPH-1503 - Manual (Page 113)

REMOTE CONTROL
113
Command :SYSTem:COMMunicate:LAN:IPADdress
Function Sets the IP address.
Description address> ASCII string, within the range of 1.0.0.0
to 223.255.255.255 (excluding
127.nnn.nnn.nnn).
Note: This commands is only applicable if for the
manual IP mode. The
SYSTem:COMMunicate:LAN:APPLy command
needs to executed before the IP address settings
can take effect.
Example :SYSTem:COMMunicate:LAN:IPADdress
172.131.161.152
Sets the IP address to 172.131.161.152.
Command
:SYSTem:COMMunicate:LAN:IPADdress?
Function Queries the IP address.
Example :SYSTem:COMMunicate:LAN:IPADdress?
Returns the IP address.
Command
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]
Function Turn the AUTO IP function on or off.
Description 0/OFF: AUTO IP off.
1/ON: AUTO IP on.
The SYSTem:COMMunicate:LAN:APPLy
command needs to be executed before the AUTO
IP function setting can take effect.
Example :SYSTem:COMMunicate:LAN:AUTOip ON
Turns the AUTO IP function on.