GW Instek PPH-1503 - Manual (Page 126)

PPH-1503 User Manual
126
you read the event register.
The following will clear the standard event register:
•The *CLS command is executed.
•The *ERR? query is used read the event register.
The following will clear the standard event enable register.
•*ESE 0 is written to the standard event enable register.
Status Byte Register Commands
Command *SRE
Function Service request enable register (SRER) command
that writes a binary weighed value which
determines which events in the status byte register
are enabled.
Function Allowed
values Decimal vales: 0～255
Example *SRE 7
0000 0111
Returns the SRER setting (0000 0111)
Command
*SRE？
Function Queries the status byte enable register. This
command returns a binary-weighted decimal
number that indicates which bits are set in the
status byte register. The range is from 0~255.
Example *SRE?
0000 0111
Returns “7”, which are the contents of the service
request enable register.