GW Instek PPH-1503 - Manual (Page 116)

PPH-1503 User Manual
116
Command :SYSTem:COMMunicate:LAN:MANualip[:STATe]
Function Allow the IP address to be set manually.
0/OFF: disable the manual IP address.
1/ON: enable the manual IP address.
Example :SYSTem:COMMunicate:LAN:MANualip ON
Enables a manual IP address to be set.
Command :SYSTem:COMMunicate:LAN:MANualip[:STATe]
?
Function Queries whether manual IP addressing has been
enabled or disabled.
Example :SYSTem:COMMunicate:LAN:MANualip？
Returns the status of the manual IP addressing.
Command :SYSTem:COMMunicate:LAN:APPLy
Function When this command is executed, all the LAN
settings are applied.
Example :SYSTem:COMMunicate:LAN:APPLy
Applies all the LAN settings.
Command :SYSTem:REMote
Function Sets the unit to remote control.
Example :SYSTem:REMote
Sets to remote control mode
Command :SYSTem:BEEPer:STATe
Function Turn the buzzer on or off.