GW Instek PSW-Series User Manual - Manual (Page 92)

PSW Series User Manual
92
Note
Error messages: If you try to run a test script from
an empty memory location “Err 003” will be
displayed on the display.
Note
When a script starts to run, there is no way to abort
the script. Pressing the Output key has no effect. If
you wish to stop a test early, turn the power off.
Run Test Script (Automatically at Startup)
Overview The power supply can be configured to
automatically run a test script at startup.
Steps 1. Before a test script can be run, it
must first be loaded into one of the
10 memory save slots.
Page 90
2. Turn the unit off.
3. Enter the power-on configuration
settings and set F-92 (Power-ON
Output) to run the desired test
script.
Page 114
Range T001~T010*
4. The selected test script will automatically start
to run the next time the unit is powered on.