GW Instek PSW-Series User Manual - Manual (Page 83)

OPERATION
83
Bleeder Control
 The Master unit is used to control the
bleeder settings. The bleeder resistor is
always turned on for the slave unit in series
mode.
Output Voltage/
Output Current
Model Single unit 2 units
PSW 30-36 30V 60V
36A 36A
PSW 80-13.5 80V 160V
13.5 13.5A
PSW 160-7.2 160V 320V
7.2A 7.2A
PSW 30-72 30V 60V
72A 72A
PSW 80-27 80V 160V
27A 27A
PSW 160-14.4 160V 320V
14.4A 14.4A
PSW 30-108 30V 60V
108A 108A
PSW 80-40.5 80V 160V
40.5A 40.5A
PSW 160-21.6 160V 320V
21.6A 21.6A
Master-Slave Series Connection
Master-Slave
Connector The Analog Control Connector is used for both
serial and parallel connections. The way the
connector is configured determines the
behavior of the master and slave units. For the
connector pin assignment, see page 117.