GW Instek PSW-Series User Manual - Manual (Page 111)

CONFIGURATION
111
Master/Slave Sets the power supply as master or slave. See
the parallel/series operation for details, page
72.
F-93 0 = Master/Local
1 = Master/Parallel1
2 = Master/Parallel2
3 = Slave/Parallel
4 = Slave/Series (Only for 30V,
80V, 160V models)
External Out
Logic Sets the external logic as active high or low.
F-94
0= High ON, 1 = Low ON
Power Switch Trip Turns the power off if enabled when the
protection settings are tripped.
F-95 1 = Disable, 0 = Enable
Calibration
Programmable
Calibration The calibration password is used to access the
local mode calibration or other special
functions. The password used determines
which function is accessed. Please see your
distributor for details.
F-00 0000 ~ 9999