GW Instek PSW-Series User Manual - Manual (Page 106)

PSW Series User Manual
106
Bleeder Control Bleeder control turns ON/OFF the bleeder
resistor. Bleeder resistors discharge the filter
capacitors after power is turned off as a safety
measure.
F-09 0 = OFF, 1 = ON
Buzzer ON/OFF Turns the buzzer sound on or off. The buzzer is
associated with alarm sounds and keypad entry
sounds.
F-10
0 = OFF, 1 = ON
Measurement
Average Setting Determines the level of smoothing for the
average setting.
Only available for firmware version 1.5 or
above.
F-17
0 = Low, 1 = Middle, 2 = High
Lock Mode Determines the behavior of the Output key
when the panel lock is on.
Only available for firmware version 1.54 or
above.
F-19
0 = Panel lock: allow output off,
1 = Panel lock: allow output
on/off
USB/GPIB Settings
Front Panel USB
State Displays the front panel USB-A port state. This
setting is not configurable.
F-20
0 = Absent, 1 = Mass Storage