Watlow EZ-ZONE PM - Manual (Page 68)

Watlow EZ-ZONE ® PM Limit Controller • 65 • Chapter 7 Factory Page
To go to the Factory Page from the Home Page, press and hold both the Advance ‰ and Reset
RESET
keys for six
seconds.
• Press the Advance Key ‰ to move through the parameter prompts.
• Press the Up ¿ or Down ¯ keys to change the parameter value.
• Press the Reset key
RESET
to return to the Home Page.
Note:
Some of these menus and parameters may not appear, depending on the controller's options. See model
number information in the Appendix for more information. If there is only one instance of a menu, no sub-
menus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon controller part
number.
Chapter 7: Factory Page
Navigating the Factory Page
7
[CUSt]
[FCty]
Custom Setup Menu
[```1]
[CUSt]
Custom Setup (1 to 20)
[`par] Parameter
[`iid] Instance ID
[`LoC]
[FCty]
Security Setting Menu
[`LoC] Security Setting
[LoC;o] Operations Page
[pas;e] Password
[RloC]
Read Lock
[SLoC] Write Security
[loC;l] Locked Access Level
[roll] Rolling Password
[pas;u] User Password
[pas;a] Administrator Password
[ULoC]
[FCty]
Security Setting Menu
[Code] Public Key
[pass] Password
[diAg]
[FCty]
Diagnostics Menu
[diAg] Diagnostics
[``Pn] Part Number
[`rEu] Software Revision
[S;bld] Software Build Number
[``Sn] Serial Number
[dAtE] Date of Manufacture
[ip;aC] IP Actual Address Mode
[ip;a1] IP Actual Address Part 1
[ip;a2] IP Actual Address Part 2
[ip;a3] IP Actual Address Part 3
[ip;a4] IP Actual Address Part 4
[ip;a5]
IP Actual Address Part 5
[ip;a6] IP Actual Address Part 6
[`CAL]
[FCty]
Calibration Menu
[```1]
[`Cal]
Calibration (1 or 3)
[`Mu] Electrical Measurement
[ELi;o] Electrical Input Offset
[ELi;S] Electrical Input Slope
[ELo;o] Electrical Output Offset
[ELi;s] Electrical Output Slope
[ELo;s] Electrical Output Slope
[``Pn] Part Number
[Code] Code