beautypg.com

Series ez-zone, Declaration of conformity, Watlow – Watlow EZ-ZONE PM User Manual

Page 110: Iso 9001

background image

Watlow EZ-ZONE

®

PM Limit Controller

107

Appendix

Declaration of Conformity

CE DOC EZ-ZONE PM-06-09

Series EZ-ZONE

®

PM

WATLOW

an

ISO 9001

approved facility since 1996.

1241 Bundy Blvd.

Winona, MN 55987 USA

Declares that the following product:
Designation:

Series EZ-ZONE

®

PM (Panel Mount)

Model Numbers:

PM (3, 6, 8, 9 or 4)(Any Letter or number) – (1, 2, 3 or 4)(A, C, E, F or

K) (A, C, H, J or K)(Any letter or number) – (Any letter or number)(A, C,

E, F or K)(A, C, H, J or K) (Any three letters or numbers)

Classification:

Temperature control, Installation Category II, Pollution degree 2, IP66

Rated Voltage and Frequency: 100 to 240 V~ (ac 50/60 Hz)

or 15 to 36 V

Î

dc/ 24 V~ac 50/60 Hz

Rated Power Consumption:

10 VA maximum PM3, PM6 Models.

14 VA maximum PM8, PM9, PM4 Models

Meets the essential requirements of the following European Union Directives by using the relevant

standards show below to indicate compliance.

2004/108/EC Electromagnetic Compatibility Directive

EN 61326-1

2006

Electrical equipment for measurement, control and laboratory

use – EMC requirements (Industrial Immunity, Class B

Emissions).

EN 61000-4-2

1996 +A1,A2

Electrostatic Discharge Immunity

EN 61000-4-3

2006

Radiated Field Immunity 10V/M 80–1000 MHz, 3 V/M 1.4–2.7 GHz

EN 61000-4-4

2004

Electrical Fast-Transient / Burst Immunity

EN 61000-4-5

2006

Surge Immunity

EN 61000-4-6

1996 +A1,A2,A3 Conducted Immunity

EN 61000-4-11 2004

Voltage Dips, Short Interruptions and Voltage Variations Immunity

EN 61000-3-2

2006

Harmonic Current Emissions

EN 61000-3-3

1

2005

Voltage Fluctuations and Flicker

SEMI F47

2000

Specification for Semiconductor Sag Immunity Figure R1-1

1

For mechanical relay loads, cycle time may need to be extended up to 160 seconds to meet flicker

requirements depending on load switched and source impedance.

2006/95/EC Low-Voltage Directive

EN 61010-1

2001

Safety Requirements of electrical equipment for measurement,

control and laboratory use. Part 1: General requirements

Compliant with 2002/95/EC RoHS Directive

Per 2002/96/EC W.E.E.E Directive

Please Recycle Properly.

Raymond D. Feller III

Winona, Minnesota, USA

Name of Authorized Representative

Place of Issue

General Manager

June 2009

Title of Authorized Representative

Date of Issue

Signature of Authorized Representative