Watlow CLS User Manual
Cls user’s guide, Watlow controls
Table of contents
Document Outline
- Cover
- Contents
- Overview
- Introduction
- Installation
- Using the CLS
- Setup
- How to Enter the Setup Menus?
- How to Edit a Menu?
- Set up Global Parameters Menu
- Load a Job
- Save Setup to Job
- Job Select Inputs
- Job Select Input Polarity
- Output Override Digital Input
- Output Override Input Polarity
- Start-up Alarm Delay
- Keyboard Lock Status
- Power-Up Output Status
- Controller Address
- Communications Baud Rate
- Communications Protocol
- Communications Error Checking
- AC Line Frequency
- Digital Output Polarity
- EPROM Information
- Set up Loop Input
- Set up Loop Control Parameters
- Set up Loop Outputs
- Set up Loop Alarms
- Alarm Types
- High Process Alarm Setpoint
- High Process Alarm Type
- High Process Alarm Output Number
- Deviation Band Value
- High Deviation Alarm Type
- High Deviation Alarm Output Number
- Low Deviation Alarm Type
- Low Deviation Alarm Output Number
- Low Process Alarm Setpoint
- Low Process Alarm Type
- Low Process Alarm Output Number
- Alarm Deadband
- Alarm Delay
- Manual I/O Test
- PID Tuning and Control
- Troubleshooting
- Linear Scaling Examples
- Appendix A: Ramp Soak
- Introduction
- Configuring Ramp/Soak
- Setting the R/S Time Base
- Editing R/S Parameters
- Choosing a Profile to Edit
- Copying the Setup from Another Profile
- Editing the Tolerance Alarm Time
- Editing the Ready Setpoint
- Editing the Ready Event States
- Choosing and External Reset Input
- Editing a Segment
- Setting Segment Time
- Setting a Segment Setpoint
- Configuring Segment Events
- Editing Event Outputs
- Changing Event States
- Editing Segment Triggers
- Assigning an Input to a Trigger
- Changing a Trigger's True State
- Latching or Unlatching a Trigger
- Setting Segment Tolerance
- Ending a Profile
- Repeating a Profile
- Using Ramp/Soak
- Appendix B: Enhanced Process Control
- Glossary