Watlow CLS - Manual (Page 141)

Appendix A: Ramp Soak
CLS User’s Guide 133
All the menus you can reach from the RAMP/SOAK key have the same
information on the top line.
How long has the profile run?
From Single Loop display, press the RAMP/SOAK key once.
The next menu appears only if you have already assigned a profile to the
loop.
How many times has it cycled?
From Single Loop display, press the RAMP/SOAK key twice. The next
menu will appear. This menu displays the number of times the profile
has run out of the total number of cycles.
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
01 A SEG01/05 R
SET MODE? START
Loop number
Profile letter
Current segment
Number of segments in profile
Mode
(Run/Hold/Continue)
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
04 A SEG10/20 R
TIM REM=32:11
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
04 A SEG10/20 R
CYCLE NR= 10/15