Watlow CLS - Manual (Page 89)

Setup
CLS User’s Guide 81
Set up Loop Outputs
Press Yes at this prompt to access menus to change loop output
parameters for the current loop, including:
• Enable or disable outputs
• Output type
• Cycle time (for TP outputs)
• SDAC parameters (for SDAC outputs)
• Control action
• Output level limit and limit time
• Output override
• Nonlinear output curve
.
Below is the setup outputs menu tree. Both heat and cool outputs have
the same menus, so only one of each menu is shown here.
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
SETUP LOOP 03
OUTPUTS ?
Setup Loop Outputs?
Heat/Cool Control
Output?
Heat/Cool Output Type?
Heat/Cool Output Cycle
Time? (TP only )
SDAC Menus
(SDAC only )
Heat/Cool Output
Action?
Heat/Cool Output
Limit?
Heat/Cool Output
Limit Time?
Heat/Cool Override
Output?
Heat/Cool Output?
SDAC Mode?
SDAC High Value?
SDAC Low Value?