Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 92)

Chapter Three Control Reference
Sets/Queries the operation mode. In Sampling scopes, the scope can be configured for Scope, Eye or
TDR modes of operation.
OperationMode Enum
Description
Values
Eye Eye mode will continuously accumulate data for persistence type of display
Scope Scope mode will run like a real time scope.
TDR TDR mode should be used for TDR based measurements
This control is applicable in Eye mode of operation only. It controls the timebase units of the output
waveform.
1) When selected as Time, the horizontal unit will be in seconds
2) When selected as Bits, the horizontal unit will be in Uis. In this configuration, the unit interval of the
output will be calculated using value of SignalBitrate control.
Units Enum
Description
Values
Time Horizontal unit in seconds
916435 RevA 3-25