Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 253)

Chapter Four Control Reference
When this control is set to true (default is false), the TIE values the result at the output have "virtual
edges" included in the output (i.e. values which are linearly interpolated) corresponding to edges which
did NOT transit. This allows a relatively uniform in time strm of values. This feature is mostly obviated
by the processor "ParamUpSample"
IncludeVirtualEdges Bool
Description
This should be set to "true" for TIE analysis of an NRZ data stream. It should be set to false for TIE
analysis of a clock signal
DataIsNRZ Bool
Description
Timing Analysis can either performed using the edge-edge timing methodology (as was developed for
Time-Interval-Analyzers", or edge-ref, as is common for real-time oscilloscopes. Edge-Ref is highly
recommended.
IntervalType Enum
Description
Values
EDGEEDGE
EDGEREF
For edge-edge methodology, this control sets the number of UI ( unit intervals) between edges to be
analyzed.
IntervalsEdgeEdge
From 1 to 500 step 1
Integer
Range
Description
Summary
Any number of characters
String
Range
4-49 916435 RevA