Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 132)

Chapter Three Control Reference
Sets/Queries the ability to zoom horizontally by a continuously variable factor. Note that if a horizontal
zoom of 0.9 is set, while variable zoom is off, the horizontal zoom will be set to 1.0. If the variable
zoom is then enabled, the factor of 0.9 will have been remembered, and it will be used. Note that the
previous value will not be remembered during a power-cycle.
VariableHorZoom Bool
Description
Sets/Queries the vertical magnification of the trace Fx. The magnification will be in a 1 2 5 10
sequence unless VariableVerZoom has been set to True, in which case it will be continuously variable.
VerZoom
From 0.1 to 100 step (8 digits)
Double
Range
Description
Sets/Queries the vertical position of center of the grid on the zoomed trace Fx. The unit of
measurement is the screen height, that is, 0.375 means a shift of three of the eight divisions. A
positive value moves the trace downwards.
VerPos
From -1.5 to 1.5 step (8 digits)
Double
Range
Description
Sets/Queries the horizontal magnification of the trace Fx. The magnification will be in a 1 2 5 10
sequence unless variable horizontal magnification has been set.
HorZoom
From 0.1 to 1e+006 step (8 digits)
Double
Range
Description
Sets/Queries the horizontal position of center of the grid on the zoomed trace Fx. The unit of
measurement is the screen width, that is, 0.3 means a shift of three of the ten divisions. A positive
value moves the trace to the left.
HorPos
From -0.5 to 0.5 step (8 digits)
Double
Range
Description
XY app.Math.XY
916435 RevA 3-65