Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 236)

Chapter Four Control Reference
Percentage at which the width of the histogram is estimated (e.g. 50% gives the same answer as Full
Width at Half Max).
HFractionHt
From 0 to 100 step 1
Double
Range
Description
LEVELATX
app.Measure.Px.Operator (ParamEngine = "LevelAtX")
if the "TimeFromCvar" is set to true, this specifies the horizontal (x) coordinate at which the waveform
data "level" or value is to be evaluated
HorValue
From -1.79769e+308 to 1.79769e+308 step 0
Double
Range
Description
If set to true, the vertical values are restricted to actual data points, else if false the values can be
interpolated (linearly) between points.
PinToData Bool
Description
If true, the horizontal coordinate (typically time) is specified by the "HorValue" cvar, otherwise the time
is specified by the input pin.
TimeFromCvar Bool
Description
HorValue Double
PinToData Bool
TimeFromCvar Bool
MATLABPARAMETER
app.Measure.Px.Operator (ParamEngine = "MATLABParameter")
916435 RevA 4-32