Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 141)

Chapter Three Control Reference
Sets the measure gate to its default state. Valid only when in either Std. Vertical or Std. Horizontal
measurement modes. For MyMeasure see the equivalent controls under Px.
SetGateToDefault Action
Description
Data coding standard for measurements made in 'Eye Measure' mode.
DataCoding Enum
Description
Values
NRZ
RZ
If True, the eye aperature may be specified when in 'Eye Measure' mode.
UseCustomThresh Bool
Description
Eye Aperature, for measurements in 'Eye Measure' mode. Valid only when UseCustomThresh is set
to true.
EyeAperture
From 0 to 100 step 0.1
Double
Range
Description
Set to true to show marker annotation when in 'Eye Measure' mode.
ShowEyeMarkers Bool
Description
3-74 916435 RevA