Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 86)

Chapter Three Control Reference
This control will initiate DC Calibration of modules. Disconnect the inputs from all plugged in Modules
before starting calibration process.
CalibrateScope Action
' Visual Basic Script
Set app = CreateObject("LeCroy.XStreamDSO")
' Start calibration of modules
app.Acquisition.C1.CalibrateScope
Example
Description
This control is applicable in TDR operating mode only. This control turns ON or OFF TDR pulse for
given channel.
TDROn Bool
Description
This control is applicable in TDR operating mode only. This variable controls polarity of TDR pulse.
TDRPolarity Enum
Description
Values
Neg Negative Pulse
Pos Positive Pulse
This control is used for reducing edge time of TDR pulse. The reduced edge time is achieved by using
software low pass Filter. Note: The default TDR edge time is 20 pS.
TDREdgeTime
From 2e-011 to 2e-010 step 1e-012
Double
Range
Description
916435 RevA 3-19