Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 190)

Chapter Three Control Reference
Clear any accumulated result data. Useful for example to restart an average, or parameter statistics.
ClearSweeps Action
Description
Sets/Queries the persisted state of the waveform. If the Display.LockPersistence control is set to
'AllLocked' then the persisted state of all displayed waveforms will be the same. If the
Display.LockPersistence control is set to 'PerTrace' then the persisted state of each waveform may be
independently controlled.
Persisted Bool
Description
Sets/Queries the saturation threshold for persisted waveforms.
All information at this level or above will be recorded with the same color or intensity.
See the general description above for a discussion of the locked and unlocked persistence modes.
PersistenceSaturation
From 0 to 100 step 1
Integer
Range
Description
Sets/Queries the state of the Show Last Trace control. If True then when this trace is displayed in
persistence mode the last acquired waveform will be superimposed on the accumulating persistence
map.
See the general description above for a discussion of the locked and unlocked persistence modes.
ShowLastTrace Bool
Description
916435 RevA 3-123