Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 139)

Chapter Three Control Reference
Sets/Queries the level of detail for help markers (if indeed any of the selected parameter definitions
have help markers).
These markers are displayed on the source traces, and only if those traces are viewed simultaneously
with the parameter measurements.
Note: this setting is global for all Px
HelpMarkers Enum
Description
Values
Detailed Detailed help markers
Off No help markers
Simple Simple help markers
Defines the mode in which the measurement system is working.
MeasureSet Enum
Description
Values
EyeMeasure
MyMeasure Custom list, each chosen from the list of available measurements.
StdHorizontal Standard Horizontal Measurements
StdVertical Standard Vertical Measurements
Defines whether the measure results table is displayed or not.
ShowMeasure Bool
Description
Force all 'HelpMarkers' on.
(HelpMarkers are the on-trace annotation of measurement setup and results)
ShowAllHelpMarkers Action
Description
3-72 916435 RevA