Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 230)

Chapter Four Control Reference
For eye-diagram parameters which have an "aperture" setting, this defines the region over which the
eye digrams vertical information is analyzed.
It specifies the percentage of the central region of the eye (relative to 1 Unit Interval) which is used in
the analysis.
Description
EYEOVERSHOOTPOSITIVE
app.Measure.Px.Operator (ParamEngine = "EyeOvershootPositive")
For eye-diagram parameters which have an "aperture" setting, this defines the region over which the
eye digrams vertical information is analyzed.
It specifies the percentage of the central region of the eye (relative to 1 Unit Interval) which is used in
the analysis.
Aperture
From 0 to 100 step 0.1
Double
Range
Description
Aperture Double
EYEPKPKNOISE
app.Measure.Px.Operator (ParamEngine = "EyePkPkNoise")
Defines the level for which the peak noise is computed, One or Zero.
Level Enum
Description
Values
One
Zero
Aperture Double
Level Enum
916435 RevA 4-26