Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 88)

Chapter Three Control Reference
This control reflects the model number of the Module.
PodModel
Any number of characters
String
Range
Description
This control reflects the type of the Module.
PodType Enum
Description
Values
Electrical The module has an electrical signal input
ElectricalTDR The module has TDR capabilities
None
Optical The module has an optical signal input
RESULT app.Acquisition.Cx.Out.Result
Properties of the type xxxx.Out.Result.yyyy are those of the last completed acquisition. They are not affected if other
controls are changed after that acquisition was completed. This distinction between "Out.Result" properties and other
controls is most important when the trigger mode is Single or Stopped. You should treat "Out.Result" properties as read-
only.
Several of these properties mention the 'frame', this is the term used to describe the visible portion of the trace, which is
generally smaller than the acquired waveform. The frame could be used for example to display a 500pt. window onto a
1Mpt. Trace, or vertically it could be used to show the 'center' 10mV of a 100mV pk trace.
For a full overview of the properties of waveform (or other ) results, please see Chapter 1.
HORIZONTAL app.Acquisition.Horizontal
This group of variables controls the timebase, the sampling, and the trigger delay.
AcquisitionDuration Double
CISStrobeFreq Double
FindBitRate Action
FPGAStatus Register
HorOffset Double
HorScale DoubleLockstep
HorScaleVariable Bool
HorUnits String
MaxSamples DoubleLockstep
NumPoints Integer
916435 RevA 3-21